NEC NEAX 2400 ICS - Message Reminder

NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 321
Message Reminder M-19
M-19 Message Reminder
General Description
This feature allows a single-line telephone to leave a MESSAGE REMINDER at the called D
term
set.
Operating Procedure
To send a message from a single-line telephone:
1. Dial the desired internal D
term
station; receive Ringback Tone or Busy Tone.
2. Press switchhook; receive Special Dial Tone.
3. Dial the MESSAGE REMINDER access code; receive Service Set Tone.
4. At the called D
term
, the MSG LED will light to indicate a message has been set.
To review messages:
1. Press the “MSG” key; the LCD displays:
D
term
Series E
Note:
When the station number is 5 digits, “MSG” is not displayed.
To return the message:
1. Lift handset or press “SPKR” key while the message is displayed.
2. Press the “MSG” key; calling station is automatically redialed.
Service Conditions
1. This service feature is available only when the called party is a D
term
set, which has the “MSG”
key. If a message is directed to a D
term
that does not have the “MSG” key or a single-line
telephone, the calling station will hear Reorder Tone.
2. A message can only be sent if the called station is in the idle or busy condition.
3. A message cannot be sent to a D
term
engaged in calling or recalling from CALL TRANSFER -
ALL CALLS [C-11], or from CONSULTATION HOLD - ALL CALLS [C-17].
4. A maximum of four messages may be received at any one D
term
. If a fifth message is attempted,
the Reorder Tone will be transmitted to the calling party.
5. A message can be displayed at the called D
term
only when the station is on-hook.
6. A message may be cleared by displaying the message and pressing the “*” or “#” key on the
called D
term
's keypad. This is selected via System Data.
7. A message is cleared when it is obtained via the “MSG” key.
MSG XXXX XX: XX AM
(Time Display)
Calling
Station
hr. min. AM/PM
MESSAGE XXXX XX: XX AM
(Time Display)
hr. min. AM/PM
Calling
Station