NEC NEAX 2400 ICS - C-11 D Call Transfer - All Calls - D Term

NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 129
Call Transfer - All Calls - D
term
C-11D
C-11D Call Transfer - All Calls - D
term
General Description
This feature permits a D
term
user to transfer incoming or outgoing calls without Attendant assistance.
Operating Procedure
To transfer a call in progress:
1. While connected with the first party, press the “XFR” key; receive Special Dial Tone.
2. Dial the third party; receive Ringback Tone.
3. At this point, the station user can either wait and announce the call or hang up before the transfer
is completed. The LCD display for an announced transfer will be:
Transferred Party
D
term
Series E
The LCD for an unannounced transfer will be:
Transferring Party Transferred Party
D
term
Series E
Service Conditions
1. The station performing the CALL TRANSFER - ALL CALLS can disconnect before the called
party answers. If the called station does not answer within the predetermined time, ringing signal
is returned to the transferring station. See VARIABLE TIMING PARAMETERS [V-1] feature for
other selectable timing choices.
2. In the case of outgoing calls (no answer supervision), this feature may be activated only after 18
seconds have elapsed since the last digit dialed.
3. Outgoing calls with answer supervision may be transferred immediately after call is answered
(no time delay).
4. The THREE-WAY CALLING [T-2] feature can comprise not more than three parties on one
connection. The three parties connected can be as follows:
a.) three stations
b.) two stations and one trunk
XFR
XXXX
(Time Display)
TRANSFER
XXXX
(Time Display)
XFR XXXX
XXXX
(Time Display)
TRANSFER XXXX
XXXX
(Time Display)