NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 469
Station-to-Station Calling - Operator Assistance S-12
S-12 Station-to-Station Calling - Operator Assistance
General Description
This feature allows a station user to call another station within the system, with the assistance of the
ATTENDANT CONSOLE [A-3] operator.
Operating Procedure
To operate:
1. Lift the handset; receive Dial Tone.
2. Dial the operator access code (normally “0”).
3. Relay the desired station number to the Attendant.
4. The Attendant dials the station number.
5. Calling and called parties are connected when the Attendant presses the RLS key.
Service Conditions
1. The Attendant may drop out of the connection before or after the called party has answered.
2. If the called station does not answer within 30 seconds, AUTOMATIC RECALL [A-8] is activated.
The Recall Timer length is set in System Data.
3. Using this feature, the Attendant may connect the calling party to a fully-restricted station.
4. Using this feature between tenants will not be restricted, unless programmed in System Data.
Interactions
1. The ATNR command is required for all station-to-station calling.
2. The normal 5 dB PAD loss inserted for station-to-station calling may be eliminated per station.
Assign Service Feature Class that allows SFI 50, Removal of 5dB pad for Off-Premises
Extensions (OPX).
3. The Attendant Console must first be provided.
4. The Attendant cannot camp-on a station-to-station call.
To Next Page
Loading...
