EasyManua.ls Logo

NEC NEAX 2400 ICS - Authorization Code Display Elimination

NEC NEAX 2400 ICS
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NEAX2400 ICS Business Features and Specifications
Page 48
NDA-24143, Issue 4
A-99 Authorization Code Display Elimination
A-99 Authorization Code Display Elimination
General Description
(Series 6100 software enhancement)
This feature eliminates AUTHORIZATION CODE [A-20] and
FORCED ACCOUNT CODE [F-7]
from being displayed on the D
term
for security purposes.
Operating Procedure
1. Before dialing:
(Auth code/forced account code access code) + (SPDT) + (auth code/forced account
code) + (DT) + (OG access code)
Dial: (DT)-10
+ (SPDT)-1234
+ (DT)-9- 753-7000
Display on D
term
is: 10XXXX9753700010 = authorization code/forced account code
access code 1234 = authorization code/forced account code
2. After dialing:
Dial: (OG access code) + (OG code) + (SST) + (auth code/forced account code)
(DT)-9-753-7000 + (SST)-1234
Display on D
term
is: 97537000XXXX1234 = authorization code/forced account code
Service Conditions
1. When the station dials the AUTHORIZATION CODE/FORCED ACCOUNT CODE, Xs appear on
the display.
2. LAST NUMBER CALL [L-6] and SAVE AND REPEAT D
term
[S-24D] features keep dialed
information, but display Xs when these function keys are pressed.
3. SPEED CALLING SYSTEM D
term
[S-3D] feature keeps dialed digits, and all digits are
displayed at the same time when this function key is pressed.
4. ACCOUNT CODE [A-18] is displayed on D
term
.
5. This feature applies only to the calling partys D
term
.
6. This feature applies for the following dialing procedures:
7. If the network is connected by a trunk (including a CCIS trunk), and AUTHORIZATION CODE/
FORCED ACCOUNT CODE is requested at the other node, this function is not applied.
8. The calling party needs to confirm SPDT/SST if AUTHORIZATION CODE/FORCED ACCOUNT
CODE is required. The first digit may or may not be recognized as AUTHORIZATION CODE/
FORCED ACCOUNT CODE, if the inter-digit timing immediately before the AUTHORIZATION
CODE/FORCED ACCOUNT CODE is too short.
Procedure Before Dialing After Dialing
OG access without held party Yes Yes
OG access with held party Yes Yes
Attendant No No

Table of Contents

Other manuals for NEC NEAX 2400 ICS

Related product manuals