NEC NEAX 2400 ICS - E-1 D Executive Right-Of-Way - D Term

NEAX2400 ICS Business Features and Specifications
Page 238
NDA-24143, Issue 4
E-1D Executive Right-of-Way - D
term
Service Conditions (cont’d)
f.) activating a conflicting feature, such as:
ATTENDANT CAMP-ON WITH TONE INDICATION [A-1]
ATTENDANT OVERRIDE [A-7]
BOSS - SECRETARY OVERRIDE [B-5D]
BUSY VERIFICATION [B-3, B-9]
CALL HOLD [C-6, C-6D]
CALL TRANSFER [C-10,C-11,C-50, C-54]
CALL WAITING - ORIGINATING [C-31]
CALL WAITING - TERMINATING [C-12]
CONSULTATION HOLD - ALL CALLS [C-17, C-58]
DATA LINE SECURITY [D-12, D-66]
DATA PRIVACY ON DEMAND [D-17, D-68]
DIAL ACCESS TO ATTENDANT [D-2, D-71]
EXCLUSIVE HOLD - D
term
[E-4D]
MODEM POOLING [M-21]
NON-EXCLUSIVE HOLD - D
term
[N-7D]
OFF-HOOK QUEUING [O-7, O-11]
OUTGOING TRUNK QUEUING [O-2, O-2D]
PRIVACY - D
term
[P-14D]
PRIVACY RELEASE [P-18]
THREE-WAY CALLING [T-2, T-2D]
VOICE CALL [V-2, V-7]
VOICE CALL - D
term
[V-2D]
Modem Pooling Connection
Data Call through Data Adapter
Data Call through Data Module
Note:
In any of the above instances, the calling station will receive Reorder Tone.
4. If one party disconnects after the THREE-WAY CALLING [T-2] has been established, the other
two parties will remain connected.
5. EXECUTIVE RIGHT-OF-WAY can also be accessed via the dial pad (access code) or SPEED
CALLING - ONE TOUCH - D
term
[S-26D].
6. The maximum number of simultaneous executive overrides allowable is dependent on the
number of conference function trunks in the system. (Conference function is included in TSW
and MUX circuit cards.)
7. This feature can be denied on DICTATION ACCESS [D-3] and PAGING ACCESS [P-1, 28]
connections through programming in System Data.
8. If the called station has activated CALL FORWARDING - ALL CALLS [C-5] and the forwarded-
to station is busy, EXECUTIVE RIGHT-OF-WAY will bridge into the forwarded-to station.
9. It is possible, via System Data, to disable the sending of a warning tone during an EXECUTIVE
RIGHT-OF-WAY connection. Normally, the two-burst warning tone is sent when the connection
is initiated.
10. If the called station line has a party on CALL HOLD [C-6], override is not allowed to the called
station line. Also override to a station line in CALL HOLD [C-6] is denied and Reorder Tone is
provided. Terminating override calls are denied when the called party has another party in a
CONSULTATION HOLD [C-17] condition.
11. If the called station is maintenance busy and EXECUTIVE RIGHT-OF-WAY is invoked, override
is denied and Reorder Tone is returned to the calling station.