NEC NEAX 2400 ICS - Page 354

NEAX2400 ICS Business Features and Specifications
Page 324
NDA-24143, Issue 4
M-19D Message Reminder - D
term
Service Conditions
1. This feature is only available between two D
term
sets, both of which have the “MSG” key. If a
message is directed to a D
term
that does not have the MESSAGE REMINDER feature, the calling
station's LCD displays:
D
term
Series E
2. Messages can only be sent if the called station is in the idle or busy condition.
3. Messages cannot be sent while engaged in calling and recalling from CALL TRANSFER - ALL
CALLS [C-11] and from CONSULTATION HOLD - ALL CALLS [C-17].
4. A maximum of four messages may be received at any one D
term
. If a fifth message is attempted,
the LCD will display:
D
term
Series E
5. Messages can be displayed only when the station is on-hook. A message may be cleared by
displaying the message and pressing the “*” or “#” key on the called D
term
's key pad.
6. A message is cleared when it is obtained via the “MSG” key.
7. Messages cannot be cleared by the message sender.
8. A second message sent by the same calling D
term
is registered as a second unique message.
The same applies to the third and fourth messages.
9. If a message is returned to an unattended station, the station number may be stored as a LAST
NUMBER DIALED [L-6], SAVE AND REPEAT [S-24], or a new MESSAGE REMINDER may be
sent.
10. Messages are sent to the forwarded-to station, which is set by CALL FORWARDING - ALL
CALLS [C-5] or CALL FORWARDING - BUSY/DON'T ANSWER [C-2, 3].
11. Messages cannot be sent to a UCD [U-1] station when all stations in the UCD group are busy.
12. Messages are sent to a dialed station when all stations in a Station Hunting (Circular) group are
busy.
13. If CALL WAITING - ORIGINATING [C-31] automatic operation is in service, it will supersede this
service. If a third station calls and receives Busy Tone, MESSAGE REMINDER - D
term
cannot
be set.
MSG RST
(Time Display)
MESSAGE REST
(Time Display)
MSG BSY
(Time Display)
MESSAGE BUSY
(Time Display)