NEC NEAX 2400 ICS - Page 511

NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 481
Speed Calling - One Touch - D
term
S-26D
Service Conditions (cont’d)
11. FLASH ENTRY and VOICE CALL features may be combined on a SPEED CALLING-ONE
TOUCH key to activate an automatic voice-announce transfer. To program, press the SPEED
CALLING-ONE TOUCH key, press the RCL key, dial the number, press the XFR key, then press
the SPEED CALLING-ONE TOUCH key.
12. A PAGE CHANGEOVER key must be assigned to a programmable Line/Feature key to activate
the second page of SPEED CALLING-ONE TOUCH numbers.
Interactions
1. The PAGE CHANGEOVER key will not function for multi-line keys programmed as SPEED
CALLING-ONE TOUCH (AKYD, FKY = 49).
2. The PAGE CHANGEOVER key will only function for a D
term
Series II and III. It will not function
for D
term
Series I.
3. The Page Changeover function is valid for D
term
telephones mounted on either 16ELC or 8DLC
circuit cards.
4. The Page Changeover function can be activated from any condition; idle, busy, conference, etc.
5. When assigning SPEED CALLING-ONE TOUCH numbers to D
term
, if a previous number was
not assigned to a particular SPEED CALLING-ONE TOUCH button, the display will not change
when that particular button is pressed for programming (it will appear that nothing has happened;
the bottom portion of the LCD display will continue to display the date and time). Once a number
is entered, it will be displayed on the upper portion of the LCD display.
6. The same SPEED CALLING-ONE TOUCH buttons are used for Page 0 and Page 1 numbers.
The PAGE CHANGE-OVER key determines which page is selected.
7. There is no deletion of SPEED CALLING-ONE TOUCH numbers. Previously assigned numbers
can only be overwritten.
8. SPEED CALLING-ONE TOUCH may be used to store FORCED ACCOUNT CODES [F-7] and
AUTHORIZATION CODES [A-20]. Other forms of Speed Calling may not be used for FORCED
ACCOUNT CODES [F-7] and AUTHORIZATION CODES [A-20].
9. When SPEED CALLING-ONE TOUCH is used on a programmable Line/Feature key, only eight
digits may be stored.
10. SPEED CALLING-ONE TOUCH cannot be programmed to any of the keys above BTN16.
11. No more than three pauses can be entered in a row.