UX5000 IP Terminal AutoConfig Setup
2 - 34 IP Terminal AutoConfi
Setu
4.4 DHCP Server Setup Windows 2003 Server Example
1. In the DHCP server highlight the server machine on the left-hand side.
Right-click on the server and choose Define Vendor Classes.
Click ADD.
Display Name = NECUXIP
Description = auto config
In the same window down below there is a section that shows
ID, Binary, and ASCII.
Click in that window under ASCII. Now enter NECUXIP. This
should have also added 4E 45 43 44 54 37 30 30 under the
binary section. Now click on OK and close.
2. Highlight the server again then right-click and choose Set Predefined
Options.
Change the option class to NECUXIP.
Click ADD and give the following info.
Name = FTP Address
Data Type = IP address
Code = 141
Click on OK, and start the process over again
Click on ADD and give the following info.
Name = Auto Config File Name
Data Type = String
Code = 151
Click on ADD and give the following info.
Name = Download Protocol
Data Type = Byte
Code = 163
Click OK.
To Next Page
Loading...
