UX5000 IP Terminal AutoConfig Setup
UX5000 IP Resource Manual 2 - 35
3. Highlight scope options on the left hand side then right-click and choose
Configure Options.
Click Advanced and change the vendor class to NECUXIP.
Place a check mark next to 141 FTP Address. Down below
assign the IP address of the FTP server then click Apply.
Place a check mark next to 151 auto config file name. Down
below type the name of the config file that was built via IP
phone manager. Then click Apply. (Ex. Test.gz)
Place a check mark next to 163 download protocol. Down
below change the HEX address to be 0x1.
Click Apply and OK.
Setting up a DHCP server to just send the port number along with the
SIP server address.
1. In the DHCP server right-click Scope Options.
Go to Configure Options.
2. Scroll down to Option 43 Vendor Specific Information.
Put a check mark next to this and it brings up a window.
In the data field delete the 00 and add the following:
A8 02 13 DB
A8 = 168 this is sub-option 168 in option 43
02 = When using this sub-option the first byte
must be 02
13 DB = port 5080
Click Apply.
3. Scroll down to Option 120 Sip Server.
Put a check mark next to this and it brings up a window.
In the data field delete the 00 and add the following:
01 AC 10 00 0A (IP address in Hex with a 1 in the front
meaning 1st SIP server).
01 = First sip server
AC = 172
10 = 16
00 = 0
0A = 10
This sends 01 172.16.0.10 (IP address of SIP server).
Click Apply and OK.
To Next Page
Loading...
