ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Virtual Private Networking Using IPsec Connections 5-33
v1.0, April 2010
4. Complete the fields, select the radio buttons and check boxes, and make your selections from
the drop-down lists as explained Table 5-12.
Table 5-12. Add VPN Policy Settings
Item Description (or Subfield and Description)
General
Policy Name A descriptive name of the VPN policy for identification and management
purposes.
Note: The name is not supplied to the remote VPN endpoint.
Policy Type From the drop-down list, select one of the following policy types:
• Auto Policy. Some settings (the ones in the Manual Policy Parameters
section of the screen) for the VPN tunnel are generated automatically.
• Manual Policy. All settings must be specified, including the ones in the
Manual Policy Parameters section of the screen.
Select Local Gateway From the drop-down list, select one of the four WAN interfaces to function as
the local gateway.
Remote Endpoint Select a radio button to specify how the remote endpoint is defined:
• IP Address. Enter the IP address of the remote endpoint in the fields to
the right of the radio button.
• FQDN. Enter the FQDN of the remote endpoint in the field to the right of
the radio button.
Enable NetBIOS? Select this check box to allow NetBIOS broadcasts to travel over the VPN
tunnel. For more information about NetBIOS, see “Configuring NetBIOS
Bridging with IPsec VPN” on page 5-59. This feature is disabled by default.
Enable RollOver? If you have configured the VPN firewall to function in WAN auto-rollover
mode (see “Configuring the Auto-Rollover Mode and Failure Detection
Method” on page 2-18), select the Enable RollOver? check box. Then, from
the corresponding drop-down list, select the backup WAN interface. After an
auto-rollover has occurred, the VPN tunnel will be reestablished using the
backup WAN interface. This feature is disabled by default.
To Next Page
Loading...
