NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Network and System Management 8-15
v1.0, April 2010
2. In the Create New SNMP Configuration Entry section of the screen, enter the settings as
explained in Table 8-2.
3. Click the Add table button. The SNMP configuration is added to the SNMP Configuration
table.
To modify an SNMP configuration entry, click the Edit table button in the Action column of the
entry that you want to modify. The Edit SNMP Configuration screen displays, enabling you to
modify the same fields that are explained in Table 8-2.
Figure 8-4
Table 8-2. SNMP Settings
Setting Description (or Subfield and Description)
IP Address The IP addresses of the SNMP management station that is allowed to receive
the VPN firewall’s SNMP traps.
Subnet Mask The subnet mask of the SNMP management station that is allowed to receive
the VPN firewall’s SNMP traps. To allow a subnet access to the VPN firewall
through SNMP, enter a subnet mask of 255.255.255.0. In this situation, the
entire subnet that is associated with the IP address of the SNMP management
station has access through the community string.
Note: A subnet mask of 255.255.255.255 or 0.0.0.0 is not supported.
Port The SNMP trap port of the SNMP manager that is allowed to receive the VPN
firewall’s SNMP traps. The default port number is 162.
Community The community string to which the SNMP agent belongs.