NETGEAR SRX5308 - ProSafe® Quad WAN Gigabit SSL VPN Firewall - Page 290

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
9-14 Monitoring System Access and Performance
v1.0, April 2010
Connection Type The connection type can be “Static IP,” “DHCP,” “PPPoE,” or “PPTP,”
depending on whether the WAN address is obtained dynamically through a
DHCP server or assigned statically by you. For information about connection
types, see “Configuring the Internet Connections” on page 2-7.
Connection State The connection state can be either “Connected” or “Not Connected,”
depending on whether the WAN port is physically connected to a modem or
router. For information about connecting a WAN port, see the ProSafe Gigabit
Quad WAN SSL VPN Firewall SRX5308 Installation Guide
.
WAN Connection Type The detected type of Internet connection that is used on this port. The WAN
connection type can be DSL, ADSL, CableModem, T1, or T3.
Upload Connection
Speed
The maximum upload speed that is provided by your ISP.
Download Connection
Speed
The maximum download speed that is provided by your ISP.
IP Address The IP address of the WAN port.
These settings are either obtained
dynamically from your ISP or
specified by you on the WAN ISP
Settings screen for this port (see
“Manually Configuring the Internet
Connection” on page 2-11).
Subnet Mask The subnet mask of the WAN port.
Gateway The IP address of the gateway.
Primary DNS Server The IP address of the primary DNS
server.
Secondary DNS Server The IP address of the secondary DNS
server.
MAC Address The default MAC address for this port (for more information, see the note
following this table) or the MAC address that you have specified on the WAN
Advanced Options screen for this port. For information about configuring the
MAC address, see “Configuring Advanced WAN Options” on page 2-31.
Note: The default MAC addresses for the LAN and WAN ports are
00:00:00:00:00:01, shared by the LAN1, LAN2, LAN3, and LAN4 ports.
00:00:00:00:00:02, unique for WAN1 port.
00:00:00:00:00:03, unique for WAN2 port.
00:00:00:00:00:04, unique for WAN3 port.
00:00:00:00:00:05, unique for WAN4 port.
00:00:00:00:00:06, unique for DMZ port (LAN4 port), if enabled.
Table 9-4. Detailed Status Screen Fields (continued)
Setting Description (or Subfield and Description)