ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308 Reference Manual
Connecting the VPN Firewall to the Internet 2-13
v1.0, April 2010
6. If your connection is PPTP or PPPoE, your ISP requires an initial login. Enter the settings as
explained in Table 2-2.
Table 2-2. PPTP and PPPoE Settings
Setting Description (or Subfield and Description)
Austria (PPTP) If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
radio button and enter the following settings:
Account Name The account name is also known as the host name or system name.
Enter the valid account name for the PPTP connection (usually your
email “ID” assigned by your ISP). Some ISPs require you to enter
your full email address here.
Domain Name Your domain name or workgroup name assigned by your ISP, or
your ISP’s domain name. You can leave this field blank.
Idle Timeout Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period of time,
select the Idle Time radio button and, in the timeout field, enter the
number of minutes to wait before disconnecting. This is useful if your
ISP charges you based on the period that you have logged in.
My IP Address The IP address assigned by the ISP to make the connection with the
ISP server.
Server IP
Address
The IP address of the PPTP server.
Other (PPPoE) If you have installed login software, then your connection type is PPPoE. Select this
radio button and enter the following settings:
Account Name The valid account name for the PPPoE connection.
Domain Name The name of your ISP’s domain or your domain name if your ISP
has assigned one. You can leave this field blank.
Idle Timeout Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period of time,
select the Idle Time radio button and, in the timeout field, enter the
number of minutes to wait before disconnecting. This is useful if your
ISP charges you based on the period that you have logged in.
Connection
Reset
Select the Connection Reset check box to specify a time when the
PPPoE WAN connection is reset, that is, the connection is
disconnected momentarily and then reestablished. Then enter the
following settings:
Disconnect
Time
Specify the hour and minutes when the connection
should be disconnected.
Delay Specify the period in seconds after which the
connection should be reestablished.
To Next Page
Loading...
