7.1 Error messages
FRA5087
No. Messages Descriptions
－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－
40 Can't execute during calibration Execution cannot be done since calibration is
being done.
41 Duplicate tag number The tag number is duplicated.
42 Can't set Stop Phase while OSC is on
The “Stop Phase” cannot be set since the
oscillator (OSC) is in the state of “AC/DC OFF”.
43 Can't execute during acquisition or calibration
Execution cannot be done since either calibration
or data acquisition is being done.
44 Can't set, graph isn't being displayed
Setting cannot be done, since the graph is not
displayed.
45 Can't execute while OSC is on Calibration cannot be executed, since the
oscillator (OSC) is not in the state of “AC/DC
OFF”.
50 Memory overflow The memory capacity is not sufficient to secure
the required area for calculation operation.
51 Can't execute during measurement
Calculation cannot be executed since
measurement is being done.
52 No data in this tag There are no data existing in the specified tag,
and therefore, no data can be read out.
53 Calculation overflow Overflow occurred for calculation operation.
60 Memory overflow The memory capacity is insufficient to secure the
area required for “auto-sequence” operation.
61 Sequence buffer overflow The sequence buffer memory has overflowed, its
capacity being insufficient.
62 Discontinue to record sequence Recording of the sequence has been
discontinued.
70 Printer timeout The printer does not respond.
To Next Page
Loading...
