7.1 Error messages
FRA5087
No. Messages Descriptions
－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－－
25 Invalid file name The file name is invalid.
26 Illegal header An illegal header has been found in the program
code.
27 Illegal parameter An illegal parameter has been found in the
program code.
28 Parameter out of range The numerical value of the parameter has been
found to be out of the permissible range.
29 Too many parameters The number of parameters in the program code
exceeds the upper limit.
30 Too few parameters The number of parameters in the program code
exceeds the lower limit.
31 Question not permitted The current header cannot be used for asking a
question, and can only be used for setting.
32 Question only permitted The current header cannot be used for setting,
and can only be used for asking a question.
33 No data in this tag There are no data existing in the specified tag,
and therefore, no data can be read out.
34 Byte count miss mach The data cannot be received, since the number of
bytes of the binary data is not the same as that of
the data to be received.
35 Not enough memory The memory capacity is insufficient to store the
received or transmitted data.
36 This data block is currently locked
The data block with the specified tag is now
under operation and currently locked, and
therefore, cannot be transferred.
37 No axis in this axis mode The specified axis does not exist in the current
display mode.
38 GPIB bus error The GPIB error, where the handshake lines on
the GPIB bus do not match to each other.
To Next Page
Loading...
