NF WF1946B - Page 128

4.4 Arbitrary Waveform
4-62 WF1946B
(4) Edit the waveform, for example, peak clip
① Use the
and keys to produce the following display (EDIT flashes).
Waveform address Waveform data
ＡＤ：００００ ＤＴ：＋０００００
ＡＲＢ：ＳＥＬＥＣＴ ＮＡＭＥ ＥＤＩＴ ＣＯＰＹ
4
② Press
ENTER
key, then the key (AD digit flashes).
ＡＤ：００００ ＤＴ：＋０００００
ＡＲＢ：ＳＥＬＥＣＴ ＮＡＭＥ ＥＤＩＴ ＣＯＰＹ
4
③ Set the waveform address (AD) with the keypad or
MODIFY
dial.
For example, set to 1024.
④ Press the
m
key to produce the following display (the asterisk (*) is displayed).
ＡＤ：１０２４ ＤＴ：＋２３１７０ ＊
ＡＲＢ：ＳＥＬＥＣＴ ＮＡＭＥ ＥＤＩＴ ＣＯＰＹ
4
*
is interpolation type mark and indicates the linear interpolation type address. The mark appears and
extinguishes each time the
m
key is pressed.
⑤ Next, use above steps ③ and ④ to set the interpolation mark (*) to waveform address 3072.