4.4 Arbitrary Waveform
WF1946B 4-63
⑥ Press the
key for linear interpolation. In this example, the first half of the sinewave is
clipped (
). The waveform data (DT) change as a result of linear interpolation between the
starred addresses.
⑦ Press the
EXIT
key, then use the
and
keys to produce the following display
(MARK-CLEAR flashes).
１：ＡＲＢ＿０１
ＡＲＢ：
3
ＭＡＲＫ－ＣＬＥＡＲ ＣＬＥＡＲ ＳＩＺＥ
Press the
ENTER
key twice to clear the interpolation marks from addresses 1024 and 3072.
⑧ In the same manner as above steps ① to ⑥, clip the first half of a sinewave (set interpolation
marks at 5120 and 7168).
The above completes arbitrary waveform setting.
To Next Page
Loading...
