Nidec MCE Motion 2000 Touch Screen - Page 117

Spare Input and Spare Output Tables
Manual # 42-02-1P28 A3 5-29
5
BACKUP PWR Battery lowering has been activated by the APS ON input (HAPS/TAPS)
CAR DELAY Car has not been able to move. Typically due to doors being held open
CAR GONG/R Car gongs
CAR LANTDN/R Down car lanterns
CAR LANTUP/R Up car lanterns
CC REGSTRD Car call Registered. Activates for 1/2 second when a car call is registered
CC SECURED Car Call Secured. Activates for 1/2 second if a secured car call button is pressed
CFSS BUZZER Turns on when car begins to recall to CFSS floor. Turns off when car arrives or car is reas-
signed.
CFSS LIGHT This car is on CFSS operation
CFSS IN_CAR This output turns ON when the doors are fully open after answering a CFSS call. It
remains ON during CFSS In-Car operation. Turns OFF when the car goes back to Passen-
ger.
CFSS IN_USE This car is in use for CFSS and is not available
CLOSING F/R The doors are closing or attempting to close. See output DCF.
DCF/DCFR Activates to close the doors. Turns off after door lock is established. Door Close Function
DCW LIGHT_F Description:
Door Close Warning Light Front output. Used for power operated vertically sliding doors
whenever they are closed automatically or with momentary pressure by MCE. It comes on
for a predetermined time prior to the start of closing and stays on until the front doors are
closed.
Note: The closing delay may be omitted when momentary pressure closing type doors are
closed using the in-car door close button.
DCW LIGHT_R Door Close Warning Light Rear output. Used for power operated vertically sliding doors
whenever they are closed automatically or with momentary pressure by MCE. It comes on
for a predetermined time prior to the start of closing and stays on until the rear doors are
closed.
Note: The closing delay may be omitted when momentary pressure closing type doors are
closed using the in-car door close button.
DCW BUZZR_F Door Close Warning Buzzer Front output. Used for power operated vertically sliding doors
whenever they are closed automatically or with momentary pressure by MCE. It comes on
for a predetermined time prior to the start of closing and stays on until the front doors are
closed (usually after the closing warning light).
Note: The closing delay may be omitted when momentary pressure closing type doors are
closed using the in-car door close button.
DCW BUZZR_R Door Close Warning Buzzer Rear output. Used for power operated vertically sliding doors
whenever they are closed automatically or with momentary pressure by MCE. It comes on
for a predetermined time prior to the start of closing and stays on until the rear doors are
closed (usually after the closing warning light).
Note: The closing delay may be omitted when momentary pressure closing type doors are
closed using the in-car door close button.
DHOLD ON Door Hold Function Front
DHOLDR Door Hold Function Rear
DHOLD END/R Door hold function ending warning buzzer
DISABLE PI Disable PI outputs
DISAUTOCLSF Disable Auto Close Front. Used on freight doors that are not controlled by MCE, this output
comes when front door auto closing is not allowed (Fire recall complete, Fire Phase II,
IND, ATS, Door Hold...).
Table 5.4 Spare Outputs
Output Description