Nikon DTM-330 - 1-2) Creating a New Job

3-79
3
MENU/1: Job
1-2) Creating a New Job
Press the [MENU] key on the Job list
screen to display the sub-function menu in
Job Manager.
Press the [1] or [ENT] key to show the
“Input Job name” screen.
Input a Job name within eight characters
and press the [ENT] key.
When you want to check the Job settings,
press the [2] key on the screen right.
Otherwise, you can just press the [ENT]
or [4] key to create a new job.
Job settings
The following 11 settings are fixed to each Job and cannot be changed
once the Job is created. These settings are separated from other
temporary settings. By this way, the data is clearly and purely stored in
the database with all necessary corrections applied at the time you store
each record.
Scale Factor: 0.999600～1.000400
T-P : ON/OFF
Sea Lvl: ON/OFF
C&R : OFF/0.132/0.200
Ｉｎｐｕｔ ＪＯＢ ｎａｍｅ
ＮＩＫＯＮ１０５
■
（ＭＡＸ ８ ｃｈａｒｓ）
A
Ｃｒｅａｔｅ ＪＯＢ？
ＮＩＫＯＮ１０５
Ｎｏ Ｓｅｔ Ｙｅｓ
Ｃｒｅａｔｅ
２ ＤＥＬ
３ Ｃｏｎｔｒｏｌ
４ Ｉｎｆｏ
1
＞
Ｓｃａｌｅ：１．００００００
Ｔ－Ｐ ：ＯＮ
Ｓｅａ Ｌｖｌ：ＯＦＦ
Ｃ＆Ｒ ：０．１３２ ↓
１
If you don’t have to change any settings from the previous Job,
just press [ENT] or [4:Yes] to create the new Job on the
confirmation screen. The current Job settings will be transferred
to the creating Job.