Nikon DTM-330 - 2-Pt Reference Plane (V-Pln)

3-58
3
S-O
4: 2-Pt Reference Plane (V-Pln)
Measuring distance and offset values on the vertical plane
Press the [4] key on the Stakeout menu
screen to start 2-Pt Reference Plane.
Input two points to define the plane.
Once the plane is defined, the calculated
Sta/dZ and coordinate will be shown. No
distance measurement is required.
[DSP], [HOT], [REC] and [ESC] keys are
available.
Sta = Horizontal distance from P1 to the target point along
the baseline
dZ = Vertical distance from P1 to the target point.
Ｉｎｐｕｔ Ｐｌａｎｅ ＰＴ１
Ｐ１：
■
Ｐ２：
1
Ｓｔａ： ６８．０２１７
ｄＺ： １７．４５９１
ＰＬＮ１／３
Inputting point by measurement is also
available. Press the [Mode] key to get
the observation screens.
Ｓｉｇｈｔ １ｓｔ Ｐｏｉｎｔ
Ｐｒｅｓｓ ＭＳＲｏｒＴＲＫ
Sta
dz
P1
P2
baseline