3-27
3
HOT
6) Qmode
This function defines the setting for
Qcode mode.
Confirm: “Yes” = displays the point input screen to confirm PT/HT/CD
before recording each measurement.
“No” = skips the point input screen and directly stores the
point after a measurement.
Meas mode (Measurement mode): Defines whether the measurement
settings for MSR or TRK are used when a key is pressed in
Qcode mode. You can use the setting defined for [MSR] or
[TRK] key. (See p.3-19)
Ｑｃｏｄｅ Ｍｏｄｅｓ
＞Ｃｏｎｆｉｒｍ ：Ｙｅｓ
Ｍｅａｓ ｍｏｄｅ：ＭＳＲ
When the average count is set to “0” (Continuous) for the selected
MSR/TRK mode, only one measurement is taken in Qcode mode.
To Next Page
Loading...
