NSD VARILIMIT VS-12PB User Manual

● 4-1 ●
4. Specifications
4-1. VS-12PB Specifications
The VS-12PB specifications are as shown below.
4-1-1. General Specifications
Item
Specifications
Power voltage
100 / 120 VAC 50 / 60Hz
Permissible power voltage range
85 to 132 VAC
Power consumption 15 or less
Leakage current
1 mA or less
Ambient operating temperature
0 to 55 °C
Ambient storage humidity
-10 to 80 °C
Ambient operating humidity
20 - 90 % RH (no condensation)
Vibration resistance
Conforms to the JIS C 0040 standard
Noise tolerance
Noise tolerance : 1500 VAC Noise width : 1 μs
Withstand resistance
1500 VAC for 1 minute between AC power terminals and case.
Insulation resistance
20 MΩ or more, measured between AC power terminals and case (measured by
500VDC insulation ohmmeter)
Operating atmosphere
Free of corrosive gases and excessive dust.
Construction
Panel mounted
Mass
2 kg or less (4.4 lb or less)
4-1-2. Performance Specifications
Item
Specifications
Number of position detection axes
1
Position detection format
Absolute detection using multi-turn or linear type ABSOCODER sensor
Positioning function
Control format
Unidirectional positioning (bidirectional positioning also possible)
Target stop position
setting format
- By key input at control panel (2 data save)
- By communication
- By external BCD input
Output signals 8 points
FWD (Forward) BRAKE (Brake release)
RVS (Reverse)
INP (In-Position)
HIS (High-speed)
RUN (Positioning progress)
LOS (Low-speed) ERR (Operation error)
Limit switch output
function
Number of programs
1 (1 additional program is possible when “communication” format is used)
Number of output channels
8 channels per program
Data setting format
Key input at control panel (and input by communication)
Functions
Main functions
Automatic positioning function, INCHING function, JOG function
Auxiliary functions PRE, Learning function, STOP zone upper / lower limit violation
detection, excessive current position change detection, excessive
correction amount detection, upper limit violation detection, lower
limit violation detection, protected switch function
Sampling time
Limit SW signals
1ms
Position output signals
External current position output
n × 4 ms (n=0 to 64) By DTC input when n=0
Minimum position setting units
0.00001
Dat a storage format
EEPROM
* For VS-T12 specifications, refer to the VS-T12 Specifications / Operation Manual.
For VS-T12B specifications, refer to the VS-T12B Specifications / Operation Manual.

NSD VARILIMIT VS-12PB Specifications

General

Brand	NSD
Model	VARILIMIT VS-12PB
Category	Switch
Language	English