NSD VARILIMIT VS-12PB - Setting the Decimal Point Position; Decimal Point Setting Procedure; Selecting the ABSOCODER Sensor Type; Sensor Selection Procedure

● 9-8 ●
9-3-2-2. Decimal point setting (Initial No.91)
Designates the decimal point position.
[1] Setting the decimal point. (Ex. : 2)
Press the key.
[2] Register (write) the setting.
Press the key to register the designated settings.
Initial No. will atomically change to No.92.
9-3-2-3. Sensor selection (Initial No.92)
[1] Select the sensor.(Ex.: MRE)
Press the key.
Designates the sensor type which is to be used.
[2] Register (write) the setting.
Press the key to register the designated settings.
Initial No. will automatically change to No.93.
Setting data
0 0 0 0 0 0 . 0
0 0 0 0 0 . 0 1
0 0 0 0 . 0 0 2
0 0 0 . 0 0 0 3
0 0 . 0 0 0 0 4
0 . 0 0 0 0 0 5
Setting data
MRE 0
VLS-256PWB 3
VLS-512PWB 4
VLS-1024PW 5
VLS-512PYB 6
VLS-1024PYB 7
VLS-2048PY 8