NSD VARILIMIT VS-12PB - Program Batch Copy Function; Copying Program Data

● 9-29 ●
9-6-7. Program Batch Copy
With this function, Program data settings can be read/written in batch, to and from the Host Controller.
Note
This function is operative regardless of the “Protect” status.
[1] Select the PROGRAM mode.
Turn the mode key-switch to the PROGRAM mode position.
[2] Designate the Program No. where copy is desired.
Press the key, then enter the number of the
Program where copy is desired.
[3] Establish the “Program Copy” mode.
Press the key to establish the Program copy mode.
[4] Designate the copy destination Program No.
Press the key, then enter the copy destination
Program No. (Program No.1 - Program No.0)
[5] Copy the Program.
Press the key to copy the Program.