NSD VARILIMIT VS-12PB - Other Operations; Password Protection for Settings

● 9-30 ●
9-7. Other Operations
9-7-1. Use of Password to Protect Data
The VS-12PB features a password function to protect the Initial and Parameter setting data. When the
password function is used, the Initial and Parameter setting data cannot be changed without first entering
the password. The password input procedure is described below.
Note
The password input should be executed before setting the Initial and Parameter data.
[1] Designate the password input status.
Set the “SET” switch at the rear of the VS-12PB to
the RUN position to enable the password function.
Once designated, settings cannot be made without
first entering the password.
[2] Designate the desired mode.
Turn the mode key switch to the desired mode (INIT
or PRMTR) position.
or Note
Once this mode is changed, setting changes will be
impossible by normal procedures.
[3] Enter the password.
Press the key, then enter the password .
[4] Resister the password.
Press the key to register the password.
[5] Designate the Initial or Parameter setting.