(b) ‘OFF area’ [limit switch ‘open (b) contact’ operation] dog position writing:
The numerical pairs used to write the ON position data are larger than those used to write the
OFF position data. If the numerical values for each dog are not written in order, beginning from
the lowest and proceeding to the highest, error ‘31’ will be activated.
(3) The ‘number of multi-dogs’ setting range is as follows:
If a setting of ‘0’ is designated, the dog ON/OFF position data at that channel will be inoperative.
Any setting exceeding ‘10’ will be processed as ‘10’.
(4) The setting range for the ON/OFF position data (scaling binary values) is as follows:
[Minimum current position value] to [Minimum current position value + scale length –1]
To Next Page