Oce VarioPrint 6180 - Change the Number of Staples

Change the number of staples
Introduction
When a job is sent to the machine, a desired number of staples for that job can be indicated.
However, you can change the number of staples on the control panel.
This section describes how to change the number of staples for a specific job.
NOTE
There must be a match between the selected output location and the job requirements. For
example, when a job does not require staples, you can select any output location. When a job
requires 1 or 2 staples, you can only select the output locations that can staple the jobs, for
example [Finisher] because the [Stacker] cannot staple the jobs. When you make a combination
that is not possible, the control panel displays an error message.
Procedure
1.
On the control panel, touch the [Jobs] button.
2.
In the list of [Waiting jobs] or [Scheduled jobs], touch the job you want to edit.
3.
Touch [Properties].
NOTE
You can also press the job 2 times to access the [Properties] window. This function is
comparable to double-clicking with a mouse.
4.
Touch the [Binding] button.
5.
Touch the desired number of staples.
6.
Touch the desired location of the staples.
7.
Touch [OK].
The [Binding] button shows the currently selected number of staples.
Change the number of staples
152
Chapter 9 - Carry out print jobs
Océ VarioPrint 6000 line