Oce VarioPrint 6180 - The power buttons and power modes

The power buttons and power modes
The power buttons
The printer has the following button to control the power supply.
Button Name Description
Sleep button The Sleep button is located at the right-hand side of the
control panel. Using the Sleep button puts the printer in-
to sleep mode, wakes the printer up from the sleep
mode or starts up the whole system, including the PRIS-
MAsync controller.
When you press the Sleep button
• when the system is off, the whole system starts up, in-
cluding the PRISMAsync controller.
• when the system is ready, the printer is put into sleep
mode. The control panel will be turned off, The PRIS-
MAsync controller remains on.
• when the system is in sleep mode, the printer wakes
up from the sleep mode.
The Sleep button allows you to switch between the
Ready mode and the Sleep mode.
The Power Modes
You can find the energy saving settings in the Settings Editor under [Preferences] -> [System
settings] -> [Energy save modes].
The Power Modes
Power mode Control panel Description
Off Off The printer and the controller are completely off. The
printer cannot receive or print any job.
Ready On The printer is ready to print jobs.
Low power mode Off The low power mode is an energy save mode.
To use the low power mode, the [Low power mode tim-
er enabled] setting in the Settings Editor must be set to
[Yes]. When this setting is disabled, the printer skips the
low power mode and goes into the sleep mode after the
time set for this mode.
When the printer has been idle for the time defined in
the [Low power mode timer] setting, the printer goes in-
to low power mode automatically.
Possible values: 1 - 15 minutes.
Factory default: 15 minutes.
The printer wakes up when a job arrives in the list of
[Scheduled jobs] or when you touch the control panel
(either the screen or any button).
4
The power buttons and power modes
44
Chapter 4 - Start the print system
Océ VarioPrint 6000 line