Activate the hotfolder function
Introduction
The information in this section is intended for system administrators.
NOTE
• By factory default, the hotfolder function is disabled. To use the hotfolder function, the system
administrator must activate this function once.
• For this procedure, the System administrator password is required.
Procedure
1.
Open the web browser and enter the host name or IP address of your PRISMAsync controller.
2.
Go to the [Workflow] -> [Hotfolders] section.
3.
Click [Configure].
4.
At [Enabled], select [Yes] to activate the hotfolder function.
5.
Enter a unique [User name] and [Password].
Make sure that you filled in the user name and password before you continue with the next step.
6.
Click [OK] to confirm the activation of the hotfolder function.
A confirmation window opens.
7.
Click [OK] to restart the controller now.
Activate the hotfolder function
Chapter 5 - Prepare the print system
65
Océ VarioPrint 6000 line
To Next Page
Loading...
