Oce VarioPrint 6180 - Troubleshooting for light-weight media

Troubleshooting for light-weight media
Introduction
When the optional light-weight media module is installed, you can print light-weight media. Next
to the general troubleshooting, you have some additional troubleshooting related to the light-
weight media module.
This section gives an overview of the possible errors related to the light-weight media module
and the solutions to these errors.
NOTE
Only operators who received the special maintenance training are allowed to replace or clean
parts and solve paper jams in the process units.
Overview of the possible machine errors
Handle the machine errors
Error Solution Additional information
Maintenance re-
quired: Remove
the sheets from
the TTF
Follow the instructions on
the control panel.
CAUTION
The TTF area can be hot.
The maintenance wizard appears. You need to
have access rights to perform maintenance
tasks.
In some cases you must remove the air guid-
ance unit to remove sheets under this unit.
You must visually check if you must remove
the unit, the system cannot indicate if the re-
moval is necessary.
NOTE
Only trained operators are allowed
to perform maintenance tasks.
Maintenance re-
quired: Replace
the air filters.
Follow the instructions on
the control panel.
The maintenance wizard appears. You need to
have access rights to perform maintenance
tasks.
NOTE
Only trained operators are allowed
to perform maintenance tasks.
Troubleshooting for the light-weight media module
Problem
Solution
Frequent paper jam at the air guid-
ance unit.
• Check the air filter of the light-weight media module.
When needed, replace the filter.
• Check the air infrastructure and the connection to the
machine.
MORPE before the job. • Check the valve of the air infrastructure and the con-
nection to the machine.
4
Troubleshooting for light-weight media
Chapter 14 - Troubleshooting
281
Océ VarioPrint 6000 line