Finisher: Add staples
Introduction
The optional finisher
The output locations
on page 21 on top of the stacker can staple your jobs.
The finisher contains 2 staplers. Both staplers are located inside the finisher. Stapler 1 is located
at the back side. Stapler 2 is located at the front side.
This section describes how to add staples.
NOTE
You can add short and long staples. It is important to add the correct staples. Use short staples if
your documents contain fewer than 50 sheets. Use long staples when your documents contain
more than 50 sheets. Only use staples of type S25 (long staples) or S37 (short staples).
When to do
When a staple cartridge is empty or almost empty
Check the status of the stapler cartridges
on
page 269.
Get access to the staplers
Procedure
1.
Open the front door of the finisher.
2.
Open top cover E1.
3.
Open cover E5.
4.
Lock cover E5 with the locking mechanism E6.
5.
If required, slide stapler 1 to the centre. This makes the access to the cartridge holder in stapler 1
easier.
Finisher: Add staples
270
Chapter 12 - Maintain the print system
Océ VarioPrint 6000 line
To Next Page
Loading...
