Perform a media registration for large media - Adjust the X-
position of side 2
Procedure
1.
Take the first test sheet.
2.
Align the start of the ruler with point 'N' of the test sheet.
Test bitmap: REGISTRATION
Size: 420 x 297 mm
2006-10-09 / 14:08:22
Page 2
2
Secondary image
K
P
ML N
1000
1050
1100
1150
1200
1250
-50
0
+50
Pri mar y X image position
Pri mar y Z image position
Pri mar y diamond shape
X length
L
[65] Align the ruler with 'N'
3.
Read the value at the edge of the test sheet.
4.
Enter the value.
5.
Take the second test sheet.
6.
Repeat the steps 2 - 4.
7.
Take the third test sheet.
8.
Repeat the steps 2 - 4.
Result
A pop-up message appears. The message asks you whether you want to print an extra test sheet
to verify the result of the registration. You can do one of the following.
• Press [Yes] if you want to print an extra test sheet to verify the result.
Wait for the sheet and check the result. Another pop-up message appears. Press [Yes] if the
registration is correct. Press [No] if the registration is not correct. Then the registration
procedure will start again.
• Press [No] if you do not want to print an extra test sheet. The registration procedure will be
finished.
Perform a media registration for large media - Adjust the X-position of side 2
Chapter 11 - Media handling
235
Océ VarioPrint 6000 line
To Next Page
Loading...
