Oce VarioPrint 6180 - Create a Transaction Setup - How to Change the PCL Parameters

Create a transaction setup - How to change the PCL parameters
Procedure
1.
Go to [Transaction Printing] - [PCL setup].
2.
Make sure that the Tray selection mechanism is set to Tray to Media.
This is the preferred setting. This printer is a media-based machine. The Tray-to-media method
supports this behavior.
3.
Change the settings under the [PCL setup] tab.
You can change the settings:
• by group (click the pencil at the right-hand side of the group settings). This is the preferred
method.
• by item (click the pencil behind the individual settings).
4.
For [PCL Tray to media for media 1] assign the [Media catalog item] from the list. The list displays
all the media in the media catalog.
When you assign A3/Ledger-like media or want to use short-edge feed for other media, change
the feed direction to [Short-edge feed (SEF)].
5.
Repeat Step 4 for all the logical trays in your setup.
Create a transaction setup - How to change the PCL parameters
Chapter 9 - Carry out print jobs
189
Océ VarioPrint 6000 line