Oce VarioPrint 6180 - Create a Hotfolder

Create a hotfolder
Introduction
The information in this section is intended for system administrator.
Before you begin
The hotfolder function must be activated. Otherwise, the system administrator must activate the
hotfolder function first.
Procedure
NOTE
For this procedure, the System administrator password is required.
1.
Open your web browser and enter the host name or IP address of your PRISMAsync controller.
2.
Go to [Workflow] -> [Hotfolders].
3.
Click [Add].
4.
Give the hotfolder a logical name.
A logical name helps you to recognize the type of jobs you want to process using this hotfolder.
5.
Select the automated workflow to which you want to link the hotfolder.
6.
Click [OK].
Create a hotfolder
66
Chapter 5 - Prepare the print system
Océ VarioPrint 6000 line