Component Function
4 Engine module The engine module contains the components that print
the media. Access to the engine module is only required
when a paper jam occurs or when maintenance is re-
quired. The doors at the left-hand side and right-hand
side of the engine module give access to the toner units.
5 Stacker The stacker is the output location of a default configura-
tion. The system supports up to 3 stackers (see
The out-
put locations
on page 21).
6 Finisher (optional) The finisher on top of the stacker is an optional output
location for the print jobs. The finisher can staple the
jobs (see
The output locations
on page 21).
7 Roll feeder (optional) A roll feeder is an optional device that adds paper input
capacity to your printer. When you use a roll feeder, you
can only use 1 or 2 paper modules. A combination of 3
paper modules and a roll feeder is not possible. The con-
trol panel displays the roll feeder and gives feedback
about the status of the roll feeder. For example whether
the roll is full or empty. Please refer to the documenta-
tion of the roll feeder manufacturer for more informa-
tion, for example about replacing an empty roll.
Introduction to the main system components
18
Chapter 2 - Explore the print system
Océ VarioPrint 6000 line
To Next Page
Loading...
