Debug Console Window Section 3-9
90
Data Replay Tool
Data Replay Tool reads the data in the specified input file and set them in
sequence as the virtual external input to the Ladder Engine.
• Replay data Display the replay file set in the [Data Replay Settings]
window.
• Output Data Display the output file set in the [Data Replay Settings]
window.
• Template Display the output template file set in the [Data Replay
Settings] window.
• Pause Pause the data replay. The button works as [Resume]
during pausing.
• Exit Exit the Data Replay Tool forcibly.
Status Bar
• Type Display the type of the input data.
• Operation Status Display the operation status of the Data Replay Tool.
• Destination FINS
address for
Connection
Display the destination FINS address for connection
where the data is replayed.
• Synchronous/
Asynchronous
Display
Display "[Synchronous]" while the synchronous replay
is performed.
Note
Refer to 8-4 Running by Virtual External Inputs for [Data Replay Tool].
[Command log]
Display the sub-menu of the Command Log.
[Command log] | [Start]
Start the Command Log with the contents of the Command Log Settings. Can
not be selected when the Command Log has been started or Command Log
Settings are not set.
To Next Page
Loading...
Need help?
General