Itala | INSTRUCTION MANUAL
3 INTRODUCTION
3.1 Manual and conventions
Opto Engineering® SpA, with its registered office in Strada Circonvallazione Sud 15, 46100 Mantova
(Mn) - Italy, hereinafter the manufacturer, provides all the necessary information in this installation,
use and maintenance manual in a clear and simple way to install, use and service the product Itala.
The recipients of this manual are all those who have the knowledge, experience and capability of
understanding the standards, prescriptions and safety measures indicated in this manual. Such
people will be later identified as qualified personnel who are authorized to transport, install, use
and service the products described in this manual.
This material can only be used by the customer whom this manual has been delivered to, in order
to install, use and service the product.
The manufacturer will retain the right to modify or improve the manual and/or the product re-
ferred to in this manual without any prior notice.
The following typographical conventions are used in this document:
NOTE: notes contain important information. Highlighted outside the text to whom they refer
CAUTION: these indications highlight procedures that, if not observed in their en-
tirety or in part, can cause damage to the machine or to the appliances
HAZARD: these indications highlight procedures that, if not observed in their entirety
or in part, can cause injuries or affect the health of the operator
3.2 Product identification data
Itala cameras are identified with a label placed on the lateral side of the packaging box. A compact
version of the label is also placed on the back side of the camera, near the connectors.
This label is used to identify the part number, serial number and MAC address of each device. A
label example is shown in Figure 1.
v1.12 - eng 13
To Next Page