Itala | INSTRUCTION MANUAL
CAMERA
Action Command Control
1 2 3 4
action time
queue
Exposure
Control
Sensor
action
command
filter
PTP
new scheduled
action
Figure 71: Scheduled Action Command block diagram.
6.13 Event Control
This section describes how to control the generation of events to the host application. An Event is
a message that is sent to the host application to notify it of the occurrence of an internal event.
Events are typically used to synchronize the host application with some Events happening in the
device.
Feature Description Interface Access
EventSelector Selects which Event to signal to
the host application
IEnumeration RW
v1.12 - eng 96
To Next Page
Loading...