Itala | INSTRUCTION MANUAL
1 GENERAL INFORMATION
1.1 Disclaimer
Always use and store Opto Engineering® products in the prescribed conditions in order to ensure
they function properly. Failing to comply with the following conditions may shorten the product
lifetime and/or result in malfunctioning, performance degradation or failure.
Be aware that incorrect functioning of this equipment may cause dangerous situations or signifi-
cant financial losses. It is essential that the users ensure that the operation of the camera is suitable
for their applications.
All trademarks mentioned herein belong to their respective owners.
Except where prohibited by law:
• All hardware, software and documentation are provided on an "as is" basis.
• Opto Engineering® accepts no liability for consequential loss, of any kind.
Upon receiving your Opto Engineering® product, visually examine it for any damage during ship-
ping. If the product is damaged upon receipt, please notify Opto Engineering® immediately.
1.2 Intended use
This product is a machine vision camera for the detection, inspection and / or measurement
of physical properties of items / objects. It provides a stream of images to a host device over a
high-speed connection. Its operation can be synchronized with other devices using various types
of electrical signals.
Please note that this product is not intended to be used as a CCTV camera in a video surveillance
system.
1.3 Forbidden use
Please read the following notes before using this camera.
Contact your distributor or dealer for any doubts or further advice.
• Do not disassemble, modify or repair the product yourself. It may cause permanent malfunc-
tioning or even fire or electric shock, possibly resulting in serious injury;
• Do not place the product in dusty, humid or hot places or near flames. These conditions may
cause malfunctioning and damage or even fire or electric shock, possibly resulting in serious
injury;
• Do not spray insecticide or apply other volatile chemicals on or around the product;
v1.12 - eng 5