opto engineering ITALA - Page 57

Itala | INSTRUCTION MANUAL
DeviceLinkThroughputLimitMode Controls if the
DeviceLinkThroughputLimit is
active
IEnumeration RW
DeviceLinkThroughputLimit Limits the maximum bandwidth
of the data that will be streamed
out by the device on the selected
Link
IInteger RW
DeviceLinkHeartbeatMode Activate or deactivate the Link’s
heartbeat
IEnumeration RW
DeviceLinkHeartbeatTimeout Controls the current heartbeat
timeout of the specific Link
IFloat RW
DeviceLinkCommandTimeout Indicates the command timeout
of the specified Link. This
corresponds to the maximum
response time of the device for a
command sent on that Link
IFloat RW
DeviceReset Resets the device to its power up
state. After reset, the device
must be rediscovered. Note that
some Transport Layers require
the acknowledgement of the
DeviceReset command before
starting the actual reset of the
device
ICommand W
DeviceFeaturePersistenceStart Indicate to the device and
GenICam XML to get ready for
persisting of all streamable
features
ICommand W
DeviceFeaturePersistenceEnd Indicate to the device the end of
feature persistence
ICommand W
DeviceRegistersStreamingStart Prepare the device for registers
streaming without checking for
consistency
ICommand W
DeviceRegistersStreamingEnd Announce the end of registers
streaming
ICommand W
DeviceTemperatureSelector Selects the location within the
device, where the temperature
will be measured
IEnumeration RW
DeviceTemperature Device temperature in degrees
Celsius (°C)
IInteger R
Table 14: Device Control features
v1.12 - eng 56