Itala | INSTRUCTION MANUAL
1.1 14/06/2022 - Added references to new camera features
- Added SDK installation section
- Added Driver installation section
- Added Itala View quick start section
- Added Itala View wizards sections
1.1.3 - 1.1.5
1.2 10/02/2023 - Added CCM calibration procedure
- Added TimerDelay feature
- Added references to SDK documentation
- Added PTP documentation
- Updated storage and operating conditions
- Updated sensor ADC resolution
- Added references to GigE mechanical specifications
- Added new part numbers in "Ordering code" section
- Added use case in Section 7.2
1.2.0 - 1.2.2
1.3 07/03/2023 - Added TriggerDelay feature
- Added Action Commands feature
- Added Serial interface configuration
- Added Serial protocol (ASCII, Modbus, Binary)
- Added PTP offset from UTC feature
1.3.0 - 1.3.2
1.4 04/05/2023 - Added DualExposure feature
- Added new part numbers in "Ordering code" section
- Added Variant in "Ordering code" section
- Updated trigger input delay in "Electrical Specifications"
1.4.0
1.5 30/05/2023 - Added TestControl feature
- Updated bandwidth limit formula
- Updated access attribute of some features
- Added Action Command section
- Correction of Dual Exposure timings
1.4.1 - 1.5.3
1.6 04/08/2023 - Added "Streaming bandwidth management" use case
- Added a caution note in the Liquid lens hardware
installation section
- Added Shock and vibration data
1.4.1 - 1.5.3
1.7 23/08/2023 - Added FCC Declaration section 1.4.1 - 1.5.3
1.8 27/09/2023 - Added Cognex Vision Pro compatibility test procedure
- Updated Encoder output mode section
- Added Encoder mode section
- Updated Dual Exposure timings
1.5.3 - 2.0.0
1.9 07/11/2023 - Updated the firmware update procedure
- Added note to TriggerWidth Exposure feature
2.0.0 - 2.0.2
1.10 20/11/2023 - Added note to DualExposure feature
- Added note to TriggerWidth Exposure feature
2.0.0 - 2.0.2
v1.12 - eng 7
To Next Page
Loading...