opto engineering ITALA

To Next Page

To Previous Page

Itala | INSTRUCTION MANUAL

Figure 61: First steps of the color calibration procedure: setting of a proper

ROI (including only the greyscale tiles of the color checker) and displaying the

results on the horizontal line proﬁler.

v1.12 - eng 81

Main Page

Table of Contents2
General Information6
Disclaimer6
Intended Use6
Forbidden Use6
Revisions7
Ordering Code9
Warranty and Certifications11
Warranty11
CE Declaration11
FCC Declaration11
KC Certification12
Shock and Vibrations12
Rohs, REACH and WEEE12
Introduction14
Manual and Conventions14
Product Identification Data14
Storage and Use Conditions15
Storage Conditions15
Operating Conditions15
Cleaning and Maintenance16
Getting Started17
Overview17
Hardware Installation17
Camera Installation17
Lens17
Ethernet Cable18
GPIO Cable18
Liquid Lens19
System Configuration20
System Requirements20
Driver Installation20
Network and Configuration22
Bandwidth Management23
Itala SDK24
Using the Camera with Itala API28
Itala SDK Documentation28
Using the Camera with Third Party Software28
Using the Camera with Itala View28
Tabs and Panels29
IP Configurator30
Firmware Update31
LUT Wizard34
Defective Pixels Correction Wizard35
Color Correction Wizard37
Technical Specifications40
Electrical Specifications42
Sensor Optical Response44
Optical Filters48
Mechanical Specifications49
Dimensional Drawings49
Gige Vision Mechanical Requirements50
Sensor Centering Data51
Connectors and Pinout52
I/O Circuitry53
Opto Isolated Input53
Opto Isolated Output54
LED and Indicators54
Camera Features56
Device Control56
Bandwidth Limit58
Image Format Control58
Image ROI60
Binning60
Decimation61
Readout Direction62
Test Pattern63
Acquisition Control64
Trigger Overlap66
Dual Exposure67
Trigger Delay69
Timed Vs Triggerwidth Exposure Mode70
Analog Control71
Gain72
White Balance72
Gamma Correction74
Black Level75
OE Auto Functions Control76
OE Autoexposure/Autogain76
LUT Control78
Lut79
Color Transformation Control80
Color Correction Matrix (CCM)80
How to Perform a Correct Color Calibration81
Digital I/O Control87
I/O Stage88
Counter and Timer Control89
Encoder Control90
Encoder Interface91
Encoder Output Mode91
Encoder Mode91
Encodervalue Wrapping Management92
Logic Block Control93
Logic Block Module94
Action Control95
Action Command95
Scheduled Action Command96
Event Control97
User Set Control99
Chunk Data Control100
OE Serial Interface Control101
Serial Interface102
OE Liquid Lens Control104
Liquid Lens Interface104
OE Defective Pixel Correction Control105
Defective Pixel Correction105
Test Control107
Transport Layer Control107
Precision Time Protocol (PTP)110
Sequencer Control110
Sequencer Overview111
Configuration of a Sequencer Set111
Use Cases114
Wiring Connection Examples114
Triggering the Camera by an External Device114
Synchronizing an External Device with Itala Cameras115
How to Add a Delay on the Output Lines of the Camera117
Streaming Bandwidth Management119
Cognex Vision Pro Compatibility123
Sequencer Control Configuration Example130
Working with Sequencer Paths130
Troubleshooting132
The Camera Cannot be Found in the Available Device List132
Why some Features Are Not Present in the Genicam Tree of the Camera Viewer132
Why Does the Camera Give Frame Losses132

opto engineering ITALA - Page 82

Table of Contents