Servicing the eUSB Drive
Caution - These procedures require that you handle components that are sensitive to static
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices to “Prevent ESD Damage” on page 41.
Caution - Ensure that all power is removed from the server before removing or installing an
eUSB drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
These topics describe how to service the eUSB drive.
■
“Remove the eUSB Drive” on page 115
■
“Install the eUSB Drive” on page 116
Related Information
■
“Detecting and Managing Faults” on page 21
■
“Preparing for Service” on page 33
Remove the eUSB Drive
This is a cold-service procedure that can be performed by a customer. Power down the server
completely before performing this procedure.
1.
Prepare for servicing.
See “Preparing for Service” on page 33.
2.
Loosen the screw that attaches the eUSB drive to the motherboard.
Save the screw to use with the new eUSB drive.
Servicing the eUSB Drive 115
To Next Page
Loading...
Need help?
General