Detecting and Managing Faults
When the server encounters a fault, the fault is recorded in a common fault database. The fault
is then reported by the server in one of several ways, depending on the type and severity of the
fault.
These topics explain how to use various diagnostic tools to monitor server status and
troubleshoot faults in the server.
Step Description Links
1. Check the server for detected faults and for
information about components that might require
service.
“Checking for Faults” on page 21
2. Perform additional troubleshooting if needed. “Performing Advanced Troubleshooting” on page 26
3. Manage faults following a service procedure. “Clear a Fault Manually” on page 31
4. Contact technical support if the problem persists.
https://support.oracle.com
Related Information
■
“Identifying Components” on page 11
■
“Preparing for Service” on page 33
■
“Returning the Server to Operation” on page 145
Checking for Faults
Use these tools to identify components that require service.
Step Description Links
1.
Run the fmadm faulty command to
display information about components
that require service.
“Log In to Oracle ILOM (Service)” on page 22
“Identify Faulted Components” on page 22
Detecting and Managing Faults 21
To Next Page
Loading...
