Remove the Cable Management Arm
Although the CMA that is supplied with the server is hinged to accommodate extending the
server, you should ensure that all cables and cords are capable of extending.
3.
From the front of the server, open and hold the left and right release latch covers
in the open position (1).
When in an open position, the release latch covers engage the slide rail release latches.
4.
While the release latch covers are in the open position, slowly pull the server
forward until the slide rails latch into a locked position (2).
The server is now in the extended maintenance position.
Related Information
■
“Disconnect Cables From the Server” on page 40
■
“Remove the Server From the Rack” on page 47
■
“Return the Server to the Normal Operating Position” on page 147
Remove the Cable Management Arm
Before you begin this procedure, refer to “Install the Cable Management Arm” in SPARC S7-2
Server Installation Guide and identify CMA connectors A, B, C, and D. You should disconnect
42 SPARC S7-2 Server Service Manual • March 2017
To Next Page
Loading...
