Log In to Oracle ILOM (Service)
Step Description Links
2.
Run the show disabled command to
display information about components
that have been disabled either
intentionally or because of a failure.
Plan to service any components that are
degraded or might need service soon to
minimize system downtime.
“Identify Disabled Components” on page 25
3. Identify the names of components that
require service as reported by diagnostic
software.
“Device Paths” on page 15
Log In to Oracle ILOM (Service)
At the terminal prompt, type:
ssh root@SP-IP-address
Password: password
Oracle (R) Integrated Lights Out Manager
Version 3.2.x
Copyright (c) 2016, Oracle and/or its affiliates, Inc. All rights reserved.
->
Related Information
■
“Identify Faulted Components” on page 22
■
“Identify Disabled Components” on page 25
■
“Device Paths” on page 15
Identify Faulted Components
You can use LEDs and software to identify faulty components, however, it is best to rely on
software to determine if a component is faulty.
The fmadm faulty command displays the list of faults detected by PSH. You can run this
command from the host or through the Oracle ILOM fault management shell.
1.
Identify fault LEDs.
22 SPARC S7-2 Server Service Manual • March 2017
To Next Page
Loading...
Need help?
General