Oracle SPARC S7-2 - Page 23

Identify Faulted Components
See “Front Panel Components” on page 11 and “Rear Panel Components” on page 13.
2.
From the Oracle ILOM prompt, start the fault management shell and type fmadm
faulty.
This example shows how to check for faults through the Oracle ILOM fault management shell.
You can also check for faults by typing show faulty at the Oracle ILOM prompt.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
------------------- ------------------------------------ -------------- -------
Time UUID msgid Severity
------------------- ------------------------------------ -------------- -------
2016-05-02/19:54:29 2782ad0c-91cb-c780-9663-807f0bf806df SPSUN4V-8001-0J MAJOR
Problem Status : open
Diag Engine : fdd 1.0
System
Manufacturer : Oracle Corporation
Name : SPARC S7-2
Part_Number : 9999991201
Serial_Number : 4568BDC0DF
----------------------------------------
Suspect 1 of 1
Fault class : fault.io.pciex.bus-linkerr-deg
Certainty : 100%
Affects : /SYS/MB/PCIE_SWITCH1/PCIE_LINK14
Status : faulted
FRU
Status : faulty
Location : /SYS/MB
Manufacturer : Oracle Corporation
Name : TLA,MB,TRAY,S7-2
Part_Number : 7329819
Revision : 01
Serial_Number : 465769T+02xxx03N
Chassis
Manufacturer : Oracle Corporation
Name : SPARC S7-2
Part_Number : 9999991201
Serial_Number : 4568BDC0DF
Resource Location : /SYS/MB/PCIE_SWITCH1/PCIE_LINK14
Description : An IO interconnect has trained at a slower speed than
Detecting and Managing Faults 23