Oracle SPARC S7-2 Service Manual

Configure POST
-> set /HOST/diag error_level=max
-> set /HOST/diag hw_change_level=max
Refer to the section on setting the SPARC host keyswitch state in the Oracle ILOM
Administrator’s Guide for Configuration and Maintenance Firmware Release 3.2.x for a
description of parameters and values.
4.
View the current values for settings.
For example, type:
-> show /HOST/diag
/HOST/diag
Targets:
Properties:
default_level = off
default_verbosity = max
error_level = off
error_verbosity = max
hw_change_level = off
hw_change_verbosity = max
Commands:
cd
set
show
->
Related Information
■
“POST Overview” on page 28
■
“Oracle ILOM Properties That Affect POST Behavior” on page 30
Oracle ILOM Properties That Affect POST
Behavior
There are a number of Oracle ILOM commands that you can use to perform host diagnostic
tests. For details about using these commands, refer to the chapter that describes configuring
host server management actions in the Oracle ILOM Administrator's Guide for Configuration
and Maintenance Firmware Release 3.2.x.
30 SPARC S7-2 Server Service Manual • March 2017

Oracle SPARC S7-2 Specifications

General

Brand	Oracle
Model	SPARC S7-2
Category	Server
Language	English