Oracle SPARC S7-2 - Page 29

Configure POST
Set default_level to min
For possible values for the default_level parameter, type:
-> help /HOST/diag
/HOST/diag : Manage Host Power On Self Test Diagnostics
Targets:
Properties:
default_level : Diag level in the default cause (no error or hw change)
default_level : Possible values = off, min, max
default_level : User role required for set = r
default_verbosity : Diag verbosity in the default cause (no error or hw
change)
default_verbosity : Possible values = none, min, normal, max
default_verbosity : User role required for set = r
error_level : Diag level when running after an error reset
error_level : Possible values = off, min, max
error_level : User role required for set = r
error_verbosity : Diag verbosity when running after an error reset
error_verbosity : Possible values = none, min, normal, max
error_verbosity : User role required for set = r
hw_change_level : Diag level when running after a hw change
hw_change_level : Possible values = off, min, max
hw_change_level : User role required for set = r
hw_change_verbosity : Diag verbosity when running after a hw change
hw_change_verbosity : Possible values = none, min, normal, max
hw_change_verbosity : User role required for set = r
->
Note - When the verbosity value is set to none, the console may not display any POST test
status for extended periods of time on certain configurations.
3.
(Optional) Set the virtual keyswitch to determine the diagnostic level after an
error reset and after a hardware change.
To set error_level, to max, and to set hw_change_level to max, type:
Detecting and Managing Faults 29