Preparing for Service
Step Description Links
1. Review safety and handling information. “Safety Information” on page 33
2. Gather the tools needed for service. “Service Tools” on page 35
3. Consider filler options. “Fillers” on page 35
4. Find the server serial number. “Find the Server Serial Number” on page 36
5. Identify the server to be serviced. “Locate the Server” on page 37
6. For cold-service operations, shut down the OS and remove
power from the server.
“Removing Power From the Server” on page 37
7. Move the server out of the rack and gain access to internal
components.
“Accessing Server Components” on page 40
Related Information
■
“Identifying Components” on page 11
■
“Returning the Server to Operation” on page 145
Safety Information
For your protection, observe these safety precautions when setting up your equipment:
■
Follow all cautions and instructions marked on the equipment and described in the
documentation shipped with your server.
■
Follow all cautions and instructions marked on the equipment and described in the SPARC
S7-2 Safety and Compliance Guide.
■
Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment's electrical rating label.
■
Follow the ESD safety practices as described in this section.
Preparing for Service 33
To Next Page
Loading...
Need help?
General